Acceptance of good and bad impacts on the living quality of the floor first to see if the same color.

<p> floor houses a direct impact on the living quality and overall appearance. .Therefore, during the inspection room, Fully furnished room floor inspection and acceptance process is an important link. .Fully furnished room with wooden floor, "common" are: color, from the dark, distortion, high and low bias and noise when walking, and bore stampede eyes, cracks, scratches and so on. .Studio with too inspector inspector description: At present, the floor fitting room is quite conspicuous. .</ P> <P> <P> <p> acceptance of solid wood flooring should first look at the color of the floor are the same </ p> <p> If the color is too large to directly affect the appearance, you can ask exchange; If the color is too consistent, .almost no color, it depends on whether the same pattern surface of the floor. .If the pattern has almost the same, then there may be craft wooden floor, not the so-called rare species of wood flooring material. .Now, some flooring suppliers, wood materials commonly used in flooring, but in the surface layer of luxury attached to shoddy veneer wood species and negative with aluminum foil and paste it is used for moisture, is afraid to see .positive and negative patterns and inconsistencies. .</ P> <p> followed by the floor to see whether there is sound, acceptance back and forth on the floor, steps shall be increased, especially in parts of the wall parts and openings to pay more attention and acceptance, the site found the sound to repeat the move .to determine the specific location of the sound, and marked. .In that case, may require the removal of resurfacing. .The site has sound, is the process of construction workers in the construction, operation and use of non-standard material failure caused. .Operating mainly in non-standard manner not firmly fixed to the keel; material failure is mainly reflected in the keel without drying. .Some renovation construction unit without drying the keel with the construction, the surface has dried traces, in fact, did not do. .</ P> <p> specification decorative timber products, moisture content should be controlled at 12% </ p> <p> high moisture content of the keel, the natural drying process in the timber volume will be reduced, resulting in loose. .Once again, whether the acceptance of the floor deformation, warping, acceptance is 2 meters long with a ruler, against the floor flatness should not exceed 3 mm. .An extra few measurements, if the pass rate of 80% or more as a pass to the contrary, is unqualified. .</ P> <p> Sometimes we find that the local bagging the floor: if it is solid wood flooring, it is too tight or the shop floor is too dry (moisture content is too low); if it is laminate flooring, it is the poor quality of the floor .. .Therefore, bagging the floor is a serious quality problems. .</ P> <p> the surface of the final acceptance of the floor if there borers eyes, cracks, scratches. .Often untreated because the keel, there are worms. .Found to have termite and other eye, the floor has been bore almost the same; cracks and scratches to see that. .Specification: floor gaps should not be larger than 0.5 mm; scratches are mainly caused by rough fitting, as with waxing method is still not repaired, it must be exchanged. .</ P>.