Fine decoration room flooring problems much more rows tutor you acceptance tips

Current fine decoration room floor problems more prominent, "common": chromatic aberration, a drum, deformation, a high and low deviation and walking walking with noise and SP eye, gap, scratches and so on, directly affects the quality of the housing and the overall appearance. The following shares some acceptance fine decoration rooms with wood floor with common sense.

According to the inspection room Planner, currently hard-cover room floor problems more prominent, "common": chromatic aberration, a drum, deformation, a high and low deviation and walking walking with noise and SP eye, gap, scratches and so on, directly affects the quality of the housing and the overall appearance. Therefore, the floor acceptance is fine decoration room acceptance process an important link in. The following shares some acceptance fine decoration rooms with wood floor with common sense.

Acceptance of solid wood flooring should first look at the color of the floor. If the color difference is too big, directly affect beauty, you can request a transfer; if the color is too inconsistent, little chromatic aberration, it depends on whether the floor surface of the tread. If the pattern is also comparable to, then it is possible that the process of wood floor, not the so-called rare wood species of wood flooring. There is now a supplier of floor materials, using wood floor General, was at the surface layer of valuable wood species of wood to shoddy, back of the park with aluminum pastes, that is used to damp-proof, but is afraid to be seen on the reverse of the pattern and positive. Secondly, it is necessary to see whether there is a noise floor, the acceptance is walking up and down on the floor, shall be increased, in particular against the wall and door parts to pay more attention to the acceptance, found sound parts, to repeat, to determine the specific location of the sound, well marked.

When this happens, you can request removal of resurfacing. Sound parts, construction workers in the construction process, the operation is not normative, and use of material is not eligible. Operation is not standardized primarily in fixed firmly to the keel; material failed concentrates and keel without baking. Some repair construction units used to without drying of keel construction, on the surface is dry, but not dry. Specification provides decorative wood products suitable for control in the moisture content of 12%. High moisture content in wood and keel natural drying process volume will decrease, resulting in a loose. If the floor is acceptance again, warping, acceptance is 2 m long ruler, on the floor, formation should not be greater than 3 mm. Smoke a few measurements, if the rate of over 80% is considered an acceptable, on the other hand, is not qualified.

Sometimes we will find the floor partial Camber: solid wood flooring, it is because the shop too tight or too dry floor (water content is too low); if it is a composite flooring, it is the poor quality of the floor. Therefore the floor camber is serious quality problem.

Final acceptance of the floor surface is boring eye, cracks, scratches. Common due to untreated keel with borers. And so found boring eye, the floor has been eaten are almost; cracks and scratches knew. Specification: floor gap should not be greater than 0.5 mm; scratches caused mainly renovation rough, such as wax method still cannot fix, you must change.