Cottage floor, experts advise not to buy an incoming "Goki products".

<p> recent years, domestic wood raw material prices soaring, the cost of production rising, the flooring industry is facing unprecedented cost pressures. .Some enterprises in order to reduce costs, shoddy, superior to inferior charge, produced called "Five Ghosts" floor of fake and shoddy products. .</ P> <P> <P> <p> "Five Ghosts" solid wood flooring products look similar, but ripped "Five Ghosts" veil of camouflage, found that they are essentially different solid wood flooring. .Genuine solid wood flooring is in the core material used for processing wood floor directly from the production of high quality paints the floor, while the "Five Ghosts" the floor is made using a variety of camouflage means the production of low-grade floor. .These products there is a "natural" defects, after the pavement easily lead to a series of problems. .</ P> <p> So, when consumers buy products, how to identify the floor in order to avoid the hit "Five Ghosts" it? .</ P> <p> 1, color plate: Take sapwood logs and core material for the transfer of part of the wood substrate, the floor surface through the use of color or special color modification of sperm processing, elimination of sapwood and the color difference between the core material .. .The sapwood and the core material of the air-dry density, moisture content, hardness of wood is not as easily lead to the floor bagging, deformation, cracking and other problems. .</ P> <p> Identification Methods: The surface of the floor sanding or sawing the floor will be presented after the end look very serious color. .</ P> <p> 2, adapter plate: with some tails and the lower plate and solid wood floor plates of different lengths through the finger splicing process and serve as a pure solid wood floor. .The use of such a large number of adhesive floor mosaic, high formaldehyde content, and because of the uneven floor easily lead to deformation of the internal stress and cracking. .</ P> <p> identification methods: the vertical sawing or grinding visible finger marks. .</ P> <p> 3, panels: the poor quality of the wood substrate thickness of 0.05mm-2mm paste wood veneer. .Such use of adhesive to the floor and the inferior wood veneer are pressed together, making it easy peeling veneer and the substrate, and there are some formaldehyde content, not environmentally friendly. .</ P> <p> identification methods: solid wood flooring wood surface and the ground is consistent, while the panels are completely different. .</ P> <p> 4, transfer plate: transfer boards are mostly made of wood with inferior grade B substrate, with the worm eyes, spotted on the surface of wood defects such as transfer patterns through a "cosmetic." .The wood floor is not natural, similar to laminate flooring at the same time, as a result of the finish paint coating process less easy to fall off, crack. .</ P> <p> identification methods: the natural wood grain of solid wood flooring, wood grain transfer printing plate surface are the same, basically no color on the back and front of the wood is completely different. .</ P> <p> 5, short-lived board: Some wood flooring business conditions due to their own, the paint adhesion, hardness, finish, etc. less than the national standards, particularly strict control of water content, resulting in shop floor .After installation in a very short time there will be deformed, finish off, do not scratch the surface and so on. .</ P> <p> </ p>.